|
 |
 |
 |
 |
|
 |
Carrying a heat load of 420,000 btu's from 2 Knight KBN210 boilers, this panel services 1 in-slab basement zone with 5 loops, plus 2 fan coils and 3 snowmelt zones. (Not Shown) One boiler is set up to handle domestic hot water on a priority basis. |
| |
 |
This 1-zone dual purpose panel with heat exchanger, connects to a hot water tank, allowing for heating one zone of in-floor heating, with a glycol/water mix, while the hot water tank also provides the domestic hot water for the home. The in-floor side is equipped with pressure reducing valve, reduced pressure backflow preventor and expansion tank. Panel is pre-wired and certified to CSA standards. |
| |
 |
A three zone dual purpose panel connects to a hot water tank, allowing for heating of three zones of in-floor heating while the hot water tank continues to provide the domestic hot water for the home. Panel is pre-wired and certified to CSA standards. |
| |
 |
Carrying a heat load of 420,000 btu’s from 2 Lochinvar Knight WBN210 Wall Mount boilers, this panel services 11 in floor heat zones, 2 fan coils, and domestic hot water, complete with Glycol feeder tank, pre-wired and certified to CSA standards – all on a 4X8 sheet of plywood. |
| |
 |
Powered by a Lochinvar WBN50 boiler, this garage panel heats 1 zone of in-slab heating on an injection system and 1 small “ snow melt” outdoor zone (manually switched). It comes complete with Tekmar mixing control and glycol feeder tank. It is pre-wired and certified to CSA standards. |
| |
| |
|
| |
|
|
|
 |
 |
 |
 |
|
